Speedzilla Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
Ok...all you SP2 owners out there. Can someone please refresh my memory and tell me how the wire harnesses route to the front of the bike in the front forks area? I have the workshop manual but it's not clear.

I am converting back to the stock side radiators from Thorsten's front set-up and can't remember how to routing goes. I think the left side harness goes over the left front radiator hose essentially sitting on top of the hose but under the radiator bracket and the right side has the kill switch harness with plug and another harness with plug tuck up and over the right radiator hose and lay next to the radiator cap.

Any help and even better yet picks when someone had their fairings off would be greatly appreciated...!

Thanks!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top