Speedzilla Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
44 Posts
Discussion Starter · #1 ·
So my old POS fiberglass ebay special of an undertail was finally replaced with a Mototek plastic undertail. The lights all wired up and work fine, but the install of the undertail is becoming an issue. Currently I have about an 1/8 of an inch on both sides of the tail. I cannot spam a plastic screws/rivet into the holes due to too much pressure.
My thought is to sinch the tail to the undertail and glue it together with silcone....Any thoughts or tricks you can give me to get this tail aligned properly.

Thanks in advance,

Airreed
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top