Speedzilla Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
My Sato Banzi high mount cans are not holding up very well. They have a mounting strap about two inches from the front of the can witch connects to the passenger peg location. This leaves can bounceing at the rear... and the rivets are getting pounded upon untill they are loose and buzzing. Was a better mount ever made for that pipe? Anyone ever had the same problem and found a cure? :rolleyes:
 

·
And Stateside again...
Joined
·
2,537 Posts
They are supposed to have a bracket that moves the mounts back a few inches. Are your straps directly bolted to your subframe?
 

·
Registered
Joined
·
401 Posts
My high mounts use a new bracket too. It drops more than the banzai but still hold the strap in the same location on the can. With the banzai cans what are you using for mid pipes.? Pics of setup?
 

·
Registered
Joined
·
4 Posts
Discussion Starter #6
Pics of mine.

Here is a picture of the bike in general I think the mid pipe is sato titanium. I didn't buy the system myself and I have never seen the original equipment so a little " show and tell " with my RC51 chums just might bring resolution to a few problems. Any thoughts are welcome.
 

Attachments

1 - 7 of 7 Posts
Top