Speedzilla Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
281 Posts
Discussion Starter #1
Question...
Are the passenger pegs from an sp2 supposed to be different sizes? I recently mounted a new set of cans on my rc and noticed that they werent sitting straight:wtf. So upon further inspection I noticed that my passenger pegs were different. Thought it was my subframe at first, but I looked at the damn pegs and they were different. Left side was longer and stuck out further then the right. Is this a normal thing? I dont think so, but I thought id ask the question and see if yall can help. My closest idea is that maybe they are different from an sp1 to an sp2 and I got one from each.
 

·
Registered
Joined
·
281 Posts
Discussion Starter #3
Yes it's normal. Look at the swing arm from the rear, it will explain it better than I can here.
I did and the left side is much longer then the right. SO youre saying this is normal and its supposed to be that way? Because my cans do not line up.
 
1 - 5 of 5 Posts
Top