Speedzilla Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
526 Posts
hey

i had to slot mine with a dremmel to use screw driver. if i remember the they are m3. i went to lowes and bought flat head screws to replace them. it sucks with those you have to thread lock them to keep them in and then they are so soft and small that the hex just strips.:mad: enjoy :rockon
 

·
Registered
Joined
·
526 Posts
900CR said:
Just grind the heads off and replace. Takes about 3 seconds. :D
after you did that how did you get the leftover nubs out :woot: without f###ing up the basket remember you ground them out cause the heads stripped cause they were tight:confused:
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top