Speedzilla Forums banner

1 - 13 of 13 Posts

·
Big Thymer
Joined
·
2,100 Posts
Discussion Starter #1
Hoping some of the RC wizards out there could help sort out what these pipes are to.

Am looking for:
  • Manufacturer
  • SP1 or SP2
  • High or Low Mount
  • Any other info
Please respond if you are like 95-100% sure. I can guess too... :)


Here is set number 1:








Here is set number 2:



 

·
Registered
Joined
·
97 Posts
Set #2 looks similar to Sato mids, but the welds on them raising a ? mark. They do not look like Sato welds.
Also, the tapered section on the Sato's is a lot higher on the mids and not at the bottom section of the pipe.
For some reason I could not post the picture, but you can use the link to see what the Sato Banzai mids looks like.

 

·
Big Thymer
Joined
·
2,100 Posts
Discussion Starter #8
Set #2 looks similar to Sato mids, but the welds on them raising a ? mark. They do not look like Sato welds.
Also, the tapered section on the Sato's is a lot higher on the mids and not at the bottom section of the pipe.
For some reason I could not post the picture, but you can use the link to see what the Sato Banzai mids looks like.

I agree... they are extremely light like SATOs are (always) but the welds aren't as precise and "nickel rolled" as all SATO welds I've ever seen are... still a mystery I guess. Thnx for response (and help)!.
 
1 - 13 of 13 Posts
Top