Speedzilla Forums banner

1 - 3 of 3 Posts
G

·
Guest
Joined
·
0 Posts
Discussion Starter #1
anyone could point me in the right direction on how to mount a cf belly pan into a factory 748 fairing?
 
G

·
Guest
Joined
·
0 Posts
Discussion Starter #2
try a search, i know this has been brought up many times....
 
G

·
Guest
Joined
·
0 Posts
Discussion Starter #3
Re: how to mount cf bellypan? (freaky4upr)

first you'll have to trim the bottom section that curves back under the bike. then you'll have to drill a couple of holes in both the pan and fairings for mounting the dzus fasteners. i also have a single nut/bolt that holds the chin piece to the front of the belly pan and then the rear is loosely supported by safety wire.

http://www.photoreflect.com/sc...st=-1

those are my stock fairings that i trimmed to fit. not perfect but good enough for the track.
 
1 - 3 of 3 Posts
Top