Speedzilla Forums banner

fork internals question....

1041 Views 10 Replies 4 Participants Last post by  RAZR51
i have a 2000 rc and the fork is bent. as far as i can tell, the only part that is bent is the left lower. the shiny part is bent about 15 degrees. anyone have any suggestions other than fleabay? fixable? another brand? will the internals on a 929/954 work? if I get both of them. how about another front end all together from another make?

I'm just looking for another option than scouring ebay and only finding a $500 FORK TUBE. i PAID LESS THAN THAT FOR THE BIKE!

If i should just suck it up and pay and get a $500 replacement tell me that too! I can deal! Thanks for any advice.:wtf
1 - 2 of 11 Posts
There was a set on here a week or so ago, I believe in the $300 range...wingnut, was that you?
Sorry the forks were on the WERA site, I checked and they were sold.
1 - 2 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.