Speedzilla Forums banner
1 - 1 of 1 Posts

· Premium Member
1,929 Posts
Discussion Starter · #1 · (Edited)
Have this DK rear shock link for SP1 / SP2. Great shape no damage, but as seen I pulled (my machinist did) out one bearing and dust seal to take measurements.

You just need to press the bearing back in and push in dust seal. All bearings and seals are in good shape including the one that needs to be pressed back in...if I can find a press I will do it before shipping off!!

There is some measurements marked in pen but those should clean off pretty easy!

$350 at Dan Kyle:
Kyle Racing RC51 Shock Link - Welcome To Kyle Racing's Online Store


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.