[Guest]

can't decide between the S and SX model from the website. any opinions?

also, how do i go about cutting the fairing? do i need to get this done professionally, or just take a hole saw from harbor freight to it? do i do the edging with some molding or something?

thanks for any help.

 

[Guest]

Re: CYCLECAT sliders are next... (quickdraw)

while i have only done my plastics fro the RC51 and the sliders...the answer is yes on the holes saw. Ii will provide a link below which may be directily applicable in the same fashion as with the RC and provided perfect line up of the slider holes.

important to note when chosing or buying your hole saw. get the appropriate size for your sliders and secondly....don't get the fast cut hole saw with the slternating teeth that kick out- get the straight in line teeth and the smaller teeth you can find or your will be dicing up those plastics for sure. iif you are doing the through bolt installation with a smaller battery on the SBKS this may help with the hole drilling alignment.
choose the mods section on the left then go down to the slider install read. good luck

http://www.rc51.org

 

[Guest]

Re: CYCLECAT sliders are next... (throttlehead)

very informative

as i will be putting mine on this weekend

 

[Guest]

Re: CYCLECAT sliders are next... (quickdraw)

thanks guys. S or SX model?

 

[Guest]

Re: CYCLECAT sliders are next... (throttlehead)

WOW, cool site, throttlehead. thanks a lot.

 

[Guest]

Re: CYCLECAT sliders are next... (quickdraw)

It really is great site...and the forum "paid" club was great as well.....not ever an "oil" question

however, I no longer can run in that world as I killed mine.

 

[Guest]

Re: CYCLECAT sliders are next... (throttlehead)

You do not want the SX model!

Chris Calovini
Sales and Markering Manager
Cycle Cat div. Ideanamics LLC
614-577-8080 x 102
[email protected]