Speedzilla Forums banner
1 - 1 of 1 Posts

· Registered
43 Posts
Discussion Starter · #1 ·
My bike won't start in gear with the clutch pulled in. I checked the kickstand switch for continuity and is working properly, and I have read 5 volts going thru those wires. I made new wires for the clutch safety switch and per the wiring diagram placed connectors in the correct locations. The system worked fine like this and has suddenly quit working. I checked the clutch switch on the bar and it's working, but I'm not reading any volts from those wires. Does any one know how many volts there should be at the switch?


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.