Speedzilla Forums banner
1 - 8 of 8 Posts
G

·
Discussion Starter · #1 ·
Just finshed installing a Barnett clutch basket -- nice piece. It looks like the basket rubs against the clutch cover gasket (I'm using the stock clutch cover). Anybody else have this problem? If so, how did you resolve it?
 
G

·
Discussion Starter · #2 ·
Re: Barnett clutch basket--gasket fit (ccolwell)

im not useing the stock cover but i had the same problem with the gasket rubbing on the basket, so i ditched the gasket.



 
G

·
Discussion Starter · #3 ·
Re: Barnett clutch basket--gasket fit (oneducs)

I am running the Barnett with no gasket. Never tried the gasket. It won't rub for long if you decide to keep it in!

Chris
 
G

·
Discussion Starter · #4 ·
Re: Barnett clutch basket--gasket fit (Vandal996)

I got rid of the gasket and it wore a grove into the stock cover.
So its all good, its got its groove on.
 
G

·
Discussion Starter · #5 ·
Thanks. I ended up trimming the gasket. The it just took some very careful installation. Can't wait to find out how much difference it makes!
 
G

·
Discussion Starter · #7 ·
Re: (HeckLer1979)

What Heckler said

Just from that small weight loss mine lost more of that, low end take off bog, than I had expected.
 
G

·
Discussion Starter · #8 ·
Re: Barnett clutch basket--gasket fit (ccolwell)

Thanks for the laugh. Never had this problem witha Nichols basket. Guess you get what you pay for.

Ducati's going to wet clutches on everything soon, anyway.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top