Speedzilla Forums banner
1 - 7 of 7 Posts

·
Registered
Joined
·
526 Posts
Discussion Starter · #1 · (Edited)
So I have everything plugged up now (for the most part) ... I have a few things to sort out still.

1. I mounted the tip over sensor in the subframe and it leans a little to the back... not to the side . Will leaning a tad to the rear affect it at all?

2. I have one connector that Im lost with... This is a HRC harness. See attached pic.

3. Adding a brake light. I know I know I know, I just put the HRC harness on to get rid of them.... BUT! if I wanna weasel my way around town to get to the back country roads... Im going to need to look "Legit". So this is my plan, Use only the front brake as a working brake light... put a LED light on the rear of the bike with a simple quick disconnect and call it a day. Before I jump into this however I just wanted to see if youo guys had any feedback... thanks!


I have few others but im going to do some searching before I open my mouth... if you guys could help me out on these it would be SWELL:notworthy
 

Attachments

·
Registered
Joined
·
526 Posts
Discussion Starter · #2 ·
heres a better pic...
 

Attachments

·
Registered
Joined
·
4,805 Posts
Yes, just rig for the front brake switch with a qick connector, Thats what I've done on the last few versions of the RC and it works great.

As far as that connector goes, it appears to be where a speedo healer plugs into. It's been some time since I had one installed but thats my :twocents
 

·
Registered
Joined
·
526 Posts
Discussion Starter · #5 ·
Thanks gents... Im more looking for the type of LED light strip to use? I remember seeing a link in a post before... i cant find it now...
 
1 - 7 of 7 Posts
Top