Speedzilla Motorcycle Message Forums - View Single Post - My 2011 R1 - a work in progress
View Single Post
post #6 of (permalink) Old 03-29-2013, 06:10 PM Thread Starter
AKDMA
Senior Member
 
AKDMA's Avatar
 
Join Date: Oct 2004
Location: WNC
Posts: 2,728
Garage
Next I purchased a 520 conversion kit with both the front and rear sprocket smaller (-2 on both), got my forks redone with Ohlins 30mm kit by Rick at Cogent, purchased some LBP titanium canisters from SimonKobe, and began my partnership with Lacomoto. Naturally, I installed a few of their CF pieces on my bike, which I'd been drooling over for some time. I installed driven AIS block off plates to get a good AFR for my autotuner, got a probolt Titanium rear axle nut (dropped less than an ounce, haha) I also did the SBK style rear brake reservoir delete. While I was under the tank, I replace the fuel line with some high pressure fuel injection hose, to avoid kinking in my fuel line. I also put some Michelin DOTs on there. Bike is finally getting close to what I'd visualized initially.
Attached Images
  


To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
and much more
along with
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
.
Aprilia SXV 550
KX450F

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.


To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.


To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Last edited by AKDMA; 05-08-2013 at 03:17 AM.
AKDMA is offline  
 
 
For the best viewing experience please update your browser to Google Chrome