Tail section wiring...

[77RRad]

Can somone take a look at the tail section wiring on there bike for the turn signals and plate light and tell me what color wires go for what light please.
Thanks
Ron

[acruhl]

It may be easier to just figure it out... This is always a problem for me no matter which bike I'm doing this on.

When you turn the key on with no turn signals enabled, you should hold onto a pair of wires going to the lights (try to find the license plate pair if you can). Keep plugging in pairs from the "bike" side until something lights up. That pair is the license plate light.

Turn on a turn signal, and go through it again. It's just a process of elimination. You can't hurt anything by doing this.

[77RRad]

Yeah I just got it figured out.
the problem was when i did LED brake/ turn signals i took all the wires out of the plug but 2.
When i put them back in and put 2 LED turn signals back on the bike i bend the female side of the plug when I put all the wires back in so they were not making contact . The was the problem from the begining.
I got it all figured out and working now.