This one has a small inclusion on the spar right above the chain guide opening on the left side. Pics show it pretty good after a few different angle shots. This swingarm, and a couple others I'm doing, were damaged and had the left rear stand boss broken off. As many well know the welds from the factory on some swingarms are kinda iffy and are prone to this problem. I had new spools fabbed up and welded back on like new. Then media-blast and then powdercoated.
New bearings and seals will be installed.
Other than that its pretty mint and the color is a very good quality match to the frame color.
Cost is $350 to the lower 48 plus actual shipping.
Also have the necessary hardware to do a swap from SP-1 for anyone that wants to go that route.
Also have an unfinished swingarm I could sell with the same set-up but obviously with the bearings un-installed.
Media-blast SP-2 swingarm with bearings new in the bag, $340 shipped to lower 48-state.
Still have the PC'd swinger pictured above as well.
Also putting in an order for a few more sets of conversion sleeves this week.
PM me if you would like a set.
Last edited by sbk_drew; 03-31-2012 at 03:27 PM.
Reason: add sleeves
Just to clarify, media-blast finish means NOT Nicky Hayden model finish or European model finish. It is currently media-blast finish, so you could either finish it in any paint or powder-coat color you want. Or sand and finish to a clear silver finish similiar to NH or Euro style finish.
Still have the two swingarms left and at the least a pivot shaft bolt to go with them.
Also have new conversion sleeves on order as well.
I'm sure someone out there has been waiting a long time to convert their SP1.
SP2 Swingarm- Newly Refurbished
).
Linear Mode
