WTB: Forks and wiring harness

[EngineNoO9`]

Well just found out that I need new forks as my got bent in the wreck and are not salvageable. So... Would like to get either some stock forks that haven't been valved, some worked forks (preferably with ohlins stuff), or any other alternative that can fit on the RC...


Also my rear harness on the bike is pretty torn up. I can probably fix it but if I can find a new one I'd prefer it...

[xrocket21]

Hey, I have a set of sp2 forks that are disassembled. All that is missing is the damper rods.

HOPEFULLY, your damper rods in your bent forks are fine, and can be installed in my forks and you can have them revalved for you at the same time.

My forks are perfectly straight. I brought them to a shop to fix a leaky fork seal, and when they got them disassembled, the damper rods were damaged. I was looking for bent forks for myself toscavenge the damper rods from, but I ended up buying a complete set of used forks instead, and now I have a box full of fork parts sitting aorund!

They were disassembled by GMD Computrack, and they assured me the forks were fine other than the damper rods.

edit: actually, if you dont want my fork parts, How much do you want for your bent forks? I'd like to finish mine and sell them

[EngineNoO9`]

I got stock forks and the harness coming my way courtesy of Rothman. Mine had racetech valving and I believe are straight. I'll get back to you on that once I figure if I'm going to swap my valving over or not. I have no point in keeping them other then for the compression and rebound valves in addition to the top out springs.

[pdfruth]

Originally Posted by xrocket21

Hey, I have a set of sp2 forks that are disassembled. All that is missing is the damper rods.

HOPEFULLY, your damper rods in your bent forks are fine, and can be installed in my forks and you can have them revalved for you at the same time.

My forks are perfectly straight. I brought them to a shop to fix a leaky fork seal, and when they got them disassembled, the damper rods were damaged. I was looking for bent forks for myself toscavenge the damper rods from, but I ended up buying a complete set of used forks instead, and now I have a box full of fork parts sitting aorund!

They were disassembled by GMD Computrack, and they assured me the forks were fine other than the damper rods.

edit: actually, if you dont want my fork parts, How much do you want for your bent forks? I'd like to finish mine and sell them

Hey xrocket, I've got a set of stock damper rods (from an 05), in perfect condition.
Here's a pic of all the fork parts I have.
Send me a PM, and we can talk offline.

Sorry for the thread jack, Engine