dp slipper clutch - replacement plates ...

mh900e0974 · #1 (**permalink**) 10-06-2007, 08:35 PM

ciao a tutti -

i have a dp slipper clutch (made by bucci) on my mh900e, and am considering putting it on the hypermotard.

question for all you hyperheads: what brand/model friction plates should i purchase to replace the old ones in this slipper clutch? surflex? stm?

any words of wisdom from the collected masses?

ciao,
johnc

**DesmoWorks** · #2 (**permalink**) 10-07-2007, 02:47 AM

I use the STM plates.... but I've never really had an issue with any plates. If I use aluminum plates I get stock 999R plates, steel I get the sintered STM. I use them with the 12T classic STM... same design as the Bucci.

mh900e0974 · #3 (**permalink**) 10-07-2007, 02:57 AM

grazie ...

the bucci ducati performance slipper i have is a 12 tooth basket design, and i see three stm pressure plate kits listed on your e-store for the 12 tooth basket. so, which set is the right one?

ciao,
johnc

Quote:

Originally Posted by DesmoWorks

I use the STM plates.... but I've never really had an issue with any plates. If I use aluminum plates I get stock 999R plates, steel I get the sintered STM. I use them with the 12T classic STM... same design as the Bucci.

**DesmoWorks** · #4 (**permalink**) 10-07-2007, 04:12 AM

This is the kit I use with slipper clutches - it is designed to have a 36-36.5mm stack height.

mh900e0974 · #5 (**permalink**) 10-09-2007, 06:07 AM

grazie mille ... now i know what kit to order when i transfer the bucci slipper from the mh900e to the hypertard.

ciao,
johnc

Quote:

Originally Posted by DesmoWorks

This is the kit I use with slipper clutches - it is designed to have a 36-36.5mm stack height.