Run out is supposed to be less than 2mm according to factory specs on oem wheels. I can only imagine aftermarket rim manufacturers hold tighter tolerances to their parts.
Its hard to tell much by the videos as i can't see the increments of measurement on the gauge. And with the rolling spin the camera shakes so much you can't see much of anything. I though i saw some noticeable axial run out but not certain due to the spotty camera work. Have you checked that as well?
Looks like the rim was repaired. If this was done through frame straight have it sent back cause he claims to get the rim to within .01 or .001 tolerances. Certainly not what it appears on the vids.
|