The chip should be assembled to the lower circuit board just like you originally received it. The entire assembly should be rotated 180 degrees and inserted into the computer.
If you notice, there's a small half-circle notch on the short end of the 748 chip and an identical notch on the upper chip of the FIM assembly. In your picture, the notches are on the opposite ends telling you that the writing on the FIM label will opposite that of the writing on the 748 chip when correctly installed.
Said another way, the notch will be on the same side of the bike as before.
Last edited by Shazaam!; 10-10-2008 at 07:25 PM.
|