I installed the Cycle Cat risers and bars on my '02 900SSie...it did take a bit of thinking and several manipulations to get everything working properly.

This may be a redundant thought, but I had to remove a 'spacer' to get the CC's to work properly...the spacer was under the stock bar clamps/above the triple's(it had nice rubber O rings protruding from each side to reduce vibrations? At some point I may install some rubber washers and see if it makes any difference in felt vibrations through the bars) . Once out of the way, installation was a snap. I didn't use the supplied clutch and brake reservoir mounts, just bent the stock ones a bit so it all went lock to lock without scraping the fairing.

Major comfort improvement over stock! MAJOR!!